Dorma ED800 J, Руководство по установке

Страница: 22 / 28

HH/RFT-1 Transmitter and HH/RFT-2 Transmitter
The HH/RFT hand held transmitters are used in conjunction with the 800RFR radio frequency
receiver. Under normal conditions, it will provide reliable activation of the ED800 within a
distance of 50 feet.
Select the code for the transmitters. The code must be identical to the code for the receiver which
is intended to be signaled. To access the code switch, remove the lower cover of the housing,
exposing the battery and the code switch. Refer to the code selection for 800RFR Radio Frequency
Receiver. Connect the 9 volt battery at this time.
1
2
3
4
5
6
7
8
9
10
open
CODE SWITCH
- +
BATTERY
CODE
SWITCH
HH/RFT-1
TRANSMITTER TOP COVER HH/RFT-1
TRANSMITTER WITH TOP
HALF OF CASE REMOVED
ON
OFF 9A
SV
1 2 3 4 5 7 6 8
1
0
9
ED800-22 08102710 05/07
If desired, a belt clip can be attached to the back of the transmitter housing by
sliding the clip completely into the slot provided.
The replacement battery is 9 volt NEDA 1604 (Eveready 216 or equivalent). If
the red LED on the transmitter fails to light when the button is depressed, it is
most likely that the battery is weak or dead, and should be replaced.
After installation is complete, check for proper operation.
KC/RFT-1 Transmitter and KC/RFT-2 Transmitter
The KC/RFT key chain transmitters are used in conjunction with the RFR radio frequency
receiver. Under normal conditions, it will provide reliable activation of the ED 800 within a
distance of 50 feet. Select the code for the transmitter. The code must be identical to the code
for the receiver which is intended to be signalled. To access the code switch, KC/RFT-1
separate the two halves of the transmitter case by inserting a coin in the side slot and twisting.
KC/RFT-2 remove the phillips head screw on back of case and carefully separate the two halves
exposing the circuit board and battery.
Refer to the code selection for 800RFR Radio Frequency Receiver. The replacement battery is a 12
volt alkaline lighter battery (Eveready A23 or equivalent).NOTE: If the red LED on the transmitter
fails to light when the button is depressed it is most likely that the battery is weak or dead and
should be replaced. It is required that the correct polarity is observed when replacing the battery.
After installation is complete, check for proper operation.
KC/RFT-2
TRANSMITTER TOP COVER
CODE
SWITCH #1
KC/RFT-2
TRANSMITTER WITH TOP
HALF OF CASE REMOVED
BATTERY
+
-
CODE
SWITCH #2