Dorex DX2 FW, Руководство по установке

Страница: 9 / 16

12. CHECK TOP LATCH FOR HOLDBACK
AND DEADLOCK (SECURE TOP STRIKE)
9 / 16
Connecting Bar
Tighten Four(4)
Side Screws
Second
Side
Screws
L
14. SECURE TWO(2) SIDE SCREWS 15. ADJUST BOTTOM ROD WITH DOOR OPEN
(TOP LATCH RETRACTED)
13. INSTALL BOTTOM LATCH AND ROD
es
Strike Screws
3rd Strike Screw
Strike Screw
E
E
E
DXAS215
DXAS106
DXAS108
Once the latchbolt is adjusted properly and engages
with the strike when the door is closed and retracts
when the door is opened; install any additional
screw(s) required to firmly secure the strike used.
FOR LESS BOTTOM ROD
MODELS (LBR) OMIT THIS
STEP AND INSTALL
AUXILIARY LATCH BOLT.
Fasten two additional side screws through the second holes
in the connecting bar and in the retractor for both the bottom
and top connecting bars.
Close Open
1. Depress exit device push bar and ensure that the bottom
latch is retracted and stays retracted after the door is
opened. Adjust the retractor screw if needed.
2. Close the door and ensure that the bottom latch engages
in the bottom strike. Adjust strike on the floor or threshold
to ensure proper latchbolt/strike engagement.
3. Open and close door few times and verify that both
latches are engaged and the latch bolt is deadlocked.
4. Secure side screws firmly when final adjustments are
completed.
Side
Screws
Rod
Sleeve
Latch Screws
Bottom Latch
Sex Bolts
Connecting Bar
F
First Holes
L
H
Retractor
Side
Screws
Second
Holes
1. Install bottom latch with two screws (or with through-bolts for fire
model).
2. Pass bottom rod through rod guide and attach connecting bar to top
of rod
3. Thread the bottom of the rod into the stud of the bottom latch until
the first holes in the end of the connecting bar align with the first
holes in the retractor and fasten with side screws
4. Ensure the bottom strike is properly aligned to engage with the
bottom latchbolt.