Dorex DX2 FV, Руководство по установке

Страница: 7 / 12

07. INSTALL MOUNTING BRACKET AND END CAP 08. INSTALL TOP LATCH AND ROD
08. INSTALL TOP LATCH AND ROD (CONTINUED)
7 / 12
Top Latch
Latch
Screws
Sex Bolts
End Cap
Screws
End Cap
End Cap Bracket
Level Device
End Cap
Bracket Screws
Amount
to
Cut Off
C
J
F
H
Figure 1
Figure 2
Cover Plate
Anti-Rattle Clip
2" Minimum
Top
Latch
Figure 3
Rod
Connecting
Screws
Rod
Connecting
Screw
Notch
Tab
F
Connecting
Bar
Second
Holes
Side
Screws
1. Remove cover plate, insert end cap bracket into the push
bar rail assembly as shown.
2. Level exit device, then mark both mounting hole centers.
Drill and tap, then fasten bracket with the appropriate
mounting screws.
3. Insert cover plate, then slide anti-rattle clip into
position (minimum 2" from end) before fixing end
cap with supplied screws.
1. Align top latch with top strike then install
top latch with two mounting screws (and
through-bolts for Fire). Adjust strike for
proper engagement. (Figure 1.)
2. Supplied rods are for 7 ft (84") door
height. if door height is less than 7 ft,
shorten the top rod by the difference
(Figure 2). Refer to page 10.
3. Attach the connecting Bar to the bottom of the top
rod with supplied screw (Figure 3)
Connecting
Bar
Connecting
Bar
NOTE:
Match notch of the connect-
ing link with tab of rod before
tighten connecting screw
4. Assemble rod guide with rod, thread rod into top latch until first
hole in connecting bar align with first hole in retractor and
fasten with side screws.
Rod
Guide
First Holes
Actual
Door
Opening
Height