Dorex DX2 FV, Руководство по установке

Страница: 4 / 12

4 / 12
DOOR PREPARATION CHART
SEE TRIM INSTALLATION INSTRUCTIONS, TEMPLATES, OR
DOOR PREPARATION DOCUMENTS FOR DETAILS.
CL
CL
X
X
METAL
ROD GUIDES
#25 DRILL
#10-24 TAP
TOP STRIKE
#25 DRILL
#10-24 TAP
METAL
METAL
LATCHES
METAL
#25 DRILL
#10-24 TAP
SURFACE MOUNT
WOOD
¹/ 8 " DRILL
PILOT 1" DEEP DRILL THRU
1/4" DRILL
(DEVICE SIDE)
DRILL
(TRIM SIDE)
METAL
WOOD
SEX BOLTS
INSIDE
OUTSIDE
RHR LHR
RHR shown(LHR opposite)
¹/ 4 " Radius
CUT-OUT
DEVICE SIDE ONLY ⁵ / 8 " DEEP FOR
WOOD DOOR
#7 DRILL
#1/4"-20 TAP
#25 DRILL
#10-24 TAP
METAL
SURFACE MOUNT
N/A
¹³/ 32 "
¹³/ 32 "
USE SUPPLIED MOUNTING
HARDWARE OR APPROPRIATE
FLOOR ANCHORS FOR THE
APPROPRIATE BOTTOM STRIKE
END CAP BRACKET 2-HOLES
CENTER CASE 2-HOLES
CENTER CASE 2-HOLES
BOTTOM STRIKE
DOOR CUT-OUTS
USE APPROPRIATE
TEMPLATE FOR THE
SUPPLIED STRIKE
PREPARE HOLES FOR THE END CAP BRACKET
MOUNTING HOLES AFTER THE EXIT DEVICE
CENTER CASE INSTALLATION AND AFTER
LEVELING THE EXIT DEVICE.
Level
5/16” DRILL
ON DEVICE SIDE
13/32” DRILL
ON TRIM SIDE
13/32” DRILL
THRU
1/8” DRILL
PILOT HOLE 1” DEEP
1/8” DRILL
PILOT HOLE 1” DEEP
WOOD
WOOD
WOOD
WOOD
5/16" DRILL ON DEVICE SIDE
13/32" DRILL ON EXTERIOR SIDE
(FOR THRU BOLTS)
1/2" DRILL THRU HOLE
(FOR TRIM POSTS)
1/8” DRILL
PILOT HOLE , 1” DEEP
13/32" DRILL THRU
(FOR THRU BOLTS)
1/2" DRILL THRU HOLE
(FOR TRIM POSTS)
Fire Exit Hardware
is to be installed on
Fire Doors bearing
the marking “Fire
Door to be equipped
with Fire Exit
Hardware” Any
retrofit or other field
modification to a Fire
Rated opening can
potentially impact the
Fire Rating of the
opening.
IMPORTANT:
• Use supplied templates for field installations.
• Use door preparation documents for door/frame manufacturing.
• Door must be properly reinforced where the exit device chassis and latches
are mounted. The surface must be flush and flat within 1/16" (1.5 mm).
• Prepare the interior of the door using the exit device template or door
preparation and instructions.
• Prepare the exterior of door using the trim template or door preparation and
installation instructions.
• All threaded holes require a minimum material thickness
of 0.125" (3 mm).
• We recommend samples be used to verify preparation before mass door or
frame manufacturing.
• NOT RESPONSIBLE for any physical or property damage due to incorrect /
improper preparation or installation.
FOR DOOR PREPARATION
REFERENCE ONLY.
Verify that this is the latest version of
this document. We recommend
samples be used to verify preparation
before door / frame manufacturing.
SURFACE
MOUNT
FOR THRU BOLTS
OR TRIM
METAL METAL
WOOD