DPM-OTR
Version 1
2019-01-28
13
E.
DELETE SENSOR LOCATION
This step is only used when a sensor is to be removed from the memory of the monitor.
This would also be used to remove a sensor from one position and locate it to a different
position.
NOTE: To enter into the Delete Sensor Location
Programming Mode from the Normal Operation screen,
press and hold the “P” button for 5 seconds until the
“PROGRAM” screen is displayed. Then press the “P”
button four times to access the Delete Sensor Location
Programming Mode (See Figure 2-20).
In the Delete Sensor Location Programming Mode, all programmed sensors will be
displayed. If no sensors need to be deleted, proceed to the next screen by pressing the
“P” button once.
To delete a sensor, select the sensor using the arrow buttons (Figure 2-21). Hold down
the “S” button until the three digits blink and audible beeps are heard. The sensor will now
be removed (Figure 2-22). When all desired sensors are deleted, proceed to the High
Pressure Alarm Programming Mode by pressing the “P” button once. To program a
deleted sensor to a different location, or add new sensors to the monitor’s memory, press
the “P” button twice to enter into the Programming Sensor Location mode.
Figure 2-20
Figure 2-21
Figure 2-22
