DPM-OTR
Version 1
2019-01-28
12
4)
To adjust the Hour (H), Press and hold the “S” button
for 3 seconds until the first digit begins to flash. Note:
The Hour (H) will be displayed in a 24-Hour Format.
Use the “Up” and “Down” arrows to adjust the numeric
value and the “Left” and “Right” arrows to change the
digit being adjusted. Once the Hour (H) has been
entered, press and hold the “S” button for 3 seconds to
proceed to the Minute (M) setting (See Figure 2-15).
5)
To adjust the Minutes (M), Press and hold the “S” button for 3 seconds until the first
digit begins to flash. Use the “Up” and “Down” arrows to adjust the numeric value and
the “Left” and “Right” arrows to change the digit being adjusted. Once the Minute (M)
has been entered, press and hold the “S” button for 3 seconds to proceed back to the
beginning of the Date and Time Programing screen
starting at the Year (Y) setting (See Figure 2-10). To
proceed to the Unit of Measure Programming screen,
press the “P” button once. Note, press and hold “P” for
5 seconds to exit programming mode and return to
normal operating mode.
D.
PROGRAMMING THE UNIT OF MEASURE
NOTE: To enter into the Unit of Measure Programming
Mode from the Normal Operation screen, press and
hold the “P” button for 5 seconds until the “PROGRAM”
screen is displayed. Then press the “P” button three
times to access the Unit of Measure Programming Mode
(See Figure 2-17).
The default unit of measure is factory set to PSI. The
Doran monitor can also display pressure in BAR and kPa
(See Figure 2-18 and 2-19). Use the “Left” and “Right”
arrow keys to select the desired units. Press and hold the
“S” button the selection blinks and audible beeps are
heard. To proceed to the Delete Tire Sensor
Programming screen, press the “P” button once. Note,
press and hold “P” for 5 seconds to exit programming
mode and return to normal operating mode.
Figure 2-17
Figure 2-18
Figure 2-15
Figure 2-16
Figure 2-19
