DoorKing 9150-080, Инструкция по установке и эксплуатации

Страница: 7 / 52

9150-065-M-5-18 3
Reverse
Loop
Automatic
Exit Loop
Minimizes the potential
of the gate closing
when a vehicle is
present. Number and
placement of loops is
dependent on the
application.
Reverse
Loop
Minimizes the potential
of the gate closing
when a vehicle is
present. Number and
placement of loops is
dependent on the
application.
(Optional) will
provide an open
command to the
gate operator(s)
when a vehicle is
exiting the property.
Warning Sign
Moving Gate Can Cause
Serious Injury or Death
KEEP CLEAR! Gate may move at any time
without prior warning.
Do not let children operate the gate or play
in the gate area.
This entrance is for vehicles only.
Pedestrians must use separate entrance.
Moving Gate Can Cause
Serious Injury or Death
KEEP CLEAR! Gate may move at any time
without prior warning.
Do not let children operate the gate or play
in the gate area.
This entrance is for vehicles only.
Pedestrians must use separate entrance.
1 1
A
B
C
Closed Gate
Secure Side of Gate
Non-Secure Side of Gate
2
Safety Information for Slide Gate Operators
Physical Stop
Positive stops shall be required
to limit travel to the designed
fully open and fully closed
positions. These stops shall be
installed either at the top of the
gate, or at the bottom of the
gate where such stops shall
horizontally or vertically project
no more than is required to
perform their intended function.
Physical Stops
Permanently mounted and easily
visible from either side of the gate.
Warning Signs
Non-Contact Sensors (Photo Sensors)
1
2
Minimizes the potential of the gate closing on vehicular or
other traffic that loops cannot sense. It can be installed on the
secure
OR non-secure side of gate.
Helps minimize the potential of entrapment during the back
travel of the gate.
Entrapment protection devices are required to reduce the risk of injury.
Install sensors where the risk of entrapment or obstruction exists while
gate is moving.
Individual requirements will vary. See pages 25-28 for
more information on typical layout locations and setup.
Contact Sensor (Reversing Edges)
A
Minimizes the potential of the gate closing on vehicular
or other traffic that loops cannot sense.
Installed on the fence to help minimize the potential of
entrapment between the gate and fence. A filler post or
barrier MAY need to be installed between fence and gate.
B
C
Helps minimize the potential of entrapment during the
back travel of the gate.
Guide Rollers
See previous page for more information.
Separate
Pedestrian
Walkway
Located so pedestrians
cannot come in contact
with the vehicular gate.
High Risk of Entrapment Area
X X X
X X X X X X X X X
Screened
Wire Mesh
May be necessary on part
of fence
AND entire gate.
See previous page for more
information.
Fence
Fence
Illustration not to scale.
External entrapment
protection devices are
REQUIRED for operator
to function. see page 25