DoorHan SHAFT-30, Инструкция по установке и эксплуатации

Страница: 3 / 12

3
SAFETY INSTRUCTIONS
1.2. TECHNICAL SPECIFICATIONS
Parameters Characteristics
Power supply 220–240 V/ 50 Hz
Torque 30 N·m
Motor speed 1 400 rpm
Shaft hole (with key way) 25.4 mm
Manual chain length 8 m
Shaft speed 32 rpm
Gear ratio 43:1
Weight with chain 15 kg
Dimensions 370 × 230 × 100 mm
Thermal protection 120°C
Intensity 50%
Oil amount 0.25 l
Engine power 300 W
Protection class IP44
Operating temperature range –40… +55°C
№
Name Quantity
1
Operator 1
2
Bracket 1
3
Set of fastenings 1
4
Manual operator chain (8 m) 1
5
External button switch 1
6
User manual 1
1.3. OPERATOR PACKAGE
Upon receiving the operator, unpack it and inspect visually. Make sure, that the operator is not damaged. If any damages are
found, please contact your supplier.
The operator components included in the standard package are listed in the following table.
2. SAFETY INSTRUCTIONS
WARNING! IMPORTANT SAFETY INSTRUCTIONS! It is important for the safety of persons to follow safety instructions.
Save these instructions.

Follow all instructions since incorrect installation can lead to severe injury.

Shaft-30 was designed for automation of industrial sectional doors. Do not use the operator for other than intended
purposes.

DoorHan shall not be held responsible in case of injury caused by misuse of the product.

Prior to installation make sure that the door is properly balanced and moves smoothly.

Installation must be performed in accordance with the standards EN12453 and EN 12445. For countries, which are not
EC members, these requirements are to be met.

Check if the door conforms to the standards EN12604 and EN 12605 (see documentation accompanying the door). For
countries, which are not EC members, the above mentioned requirements shall be met in order to obtain an appropriate
safety level.

Mechanical units of the door shall conform to the standards EN12604 and EN 12605.

Prior to installation, check that the location of operator installation is suitable by its climatic conditions to technical
specifications of the operator.

Do not install the operator in premises containing quick inflammable substances or other dangerous environments as it
can cause explosion or fire.

During assembly, installation and adjustment use tools specified in section “Tools” of this manual.