321 VZ County Road 4500
·
Ben Wheeler, TX 75754
·
800.437.3667
·
DoorControlsUSA.com
1. Run four wires through the wall to the jamb mount box provided.
2. Connect the four wires from the back box to the wave sensor according the Wiring Diagram.
3. For weatherproof installation, use a waterproof back box and apply a bead of silicone sealant (not
included) around the rim of the back box and faceplate edge. Apply a small amount of sealant below
each screw head.
4. Screw the plate into the back box, taking care not to crimp the wires and ensuring a good seal.
5. Remove clear protective film from the sensor before use.
WARNING:
Do not connect any device that will exceed 1.2A@24VDC.
Installation:
Changing the LED Color Jumper Placement:
Adjusting the Sensor Range and Trigger Time:
1. The sensor range can be adjusted from 2”~7” (5~18 cm).
2. The trigger time can be adjustment trimpots to turn.
NOTE:
Do not force the adjustment trimpots to turn. Only
minimal force is needed.
Specifications:
Power
12-24 VDC
Standby
16mA@12VDC / 25mA@24VDC
Triggered
25mA@12VDC / 32mA@24VDC
Current
Drain
(max.)
Relay Type
SPDT dry contact, 1.2A@24VDC
Response Time
10ms
Standby
Red
†
Triggered
Green
†
LEDs
Output Time
0.8~30 s, toggle
Range
2”~7” (5~18cm)
IP Rating
IP65
†
Temperature Range
-4°~131° F (-20° ~55° C)
Color function reversible when properly installed.
Jamb Mount Models
Trigger time: 0.8~30 seconds, toggle*
Default: 0.8 seconds
*Toggle: turn all the way clockwise
Sensor range: 2”~7” (5~18 cm)
Default: 7” (18cm)
*Set trigger time to maximum for toggle