P/N 1809533 Rev. B
5
Front Drive - Side Plates
- continued
STEP 5:
Remove tarp axle, cut squarely at mark and deburr
cut end. Drill 5/16" hole 5/8" from cut end of axle,
aligning hole as shown.
drill
5/16"
hole
tarp
axle
STEP 8:
Tighten set screw on ball bearing.
tighten
set
screw
STEP 6A:
Electric motor.
Insert stub shaft through passenger
side tarp axle bracket and align tarp axle between
brackets. On driver side, insert motor shaft through
bracket and into tarp axle. Fasten motor to bracket
with supplied screws.
tarp
axle
STEP 7A:
Electric system.
Slide bearing assembly over stub
shaft and fasten to tarp axle bracket with screws
H
,
washers
Q
and nuts
M
.
electric
motor
&
cover
bearing
shaft
extension
bearing
plate
STEP 6B:
Manual crank.
On driver side, loosely fasten flange
bearing to bracket with screws
C
, washers
P
and nuts
L
. Insert stub shaft through passenger side tarp axle
bracket and align tarp axle between brackets. Insert
sprocket shaft through bearing and into tarp axle.
STEP 7B:
Manual system.
Slide bearing assembly over stub
shaft and loosely fasten to bearing plate with screws
H
, washers
Q
and nuts
M
. On driver side, adjust
sprocket location, then tighten fasteners.
passenger
side
passenger
side
driver
side
2-1/4"
driver
side
driver
side
sprocket
collar
shaft
screws
supplied
w
/
motor
M
Q
H
L
P
P
C
