Dongcheng ADZC22, Руководство по эксплуатации

Страница: 11 / 80

11
EN
1
1.Dill bit
A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. Hold the tool firmly before starting the tool to
remove the bit easily.
Do not drill in the material that may contain nails or
something that may hamper or destroy the drill bit.
2.Drilling on the steel or wood
When drilling on steel, wood or plastic, a SDS-
plus twist drill bit should be used to spin the drill
chuck into the connecting rod, tighten the screws
tightly, and then insert the connecting rod into the
machine, the method of which is the same as the drill
bit mentioned earlier and turn the operating mode
selector to the drill mode.
1 2 3 4
5
1.Lock Screw
2.Drill Chuck
3.Connecting Rod
4.Locking Sleeve
5.Twist Drill
CAUTION:
Do not set the tool to hammer mode when drilling
on the wood or metal, or the drill bit or the drill
chuck may be destroyed.
● Overload Protection
The motor will stop if it is overload during the
operation. Release the switch button then push it to
start the tool again.
●
Over Temperature Protection
Overload is not allowed during the operation of the
tool. The electronic control system will stop the tool
when it is overload or the temperature is over 75
℃℃℃
°C
.
● Deep Discharging Protection
The tool is equipped with a protective circuit to
protect the battery against deep discharging. When
the battery is near to be empty, the protective circuit
actuates to switch off the tool.
● Disposal of discarded battery packs
To protect natural resources, properly recycle or
dispose of battery packs. The battery contains a
lithium battery. Please consult your local authority for
information on recycling and/or disposal. Remove the
battery pack when it has run out of power and wrap
the pole port with strong tape to avoid short circuit
and leakage. Do not attempt to open or remove any
component.
Maintenance and servicing instructions
CAUTION:
Always be sure that the tool is switched off and the
battery is removed before attempting to perform
inspection or maintenance.
Cleaning Ventilation Slots
For safe and proper working, always keep the power
tool and its ventilation slots clean. Use a soft, clean
and dry brush to clean the ventilation slots regularly or
when they’re clogged.
Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws
be loose, retighten them immediately. Failure to do so
could result in serious hazard.
Cleaning
Only use soft and dry cloth to wipe the body of the tool.
Do not clean the tool with wet cloth, thinner, gasoline
or other volatile solvents.
Disposal
The machine, rechargeable batteries, accessories
and packaging should be sorted for environmental
friendly recycling.
Do not dispose of power tools and batteries/
rechargeable batteries into household waste!
For battery tools:
Ambient temperature range during operation and
storage: 0°C - 45°C .
Recommended ambient temperature range during
charging: 5°C - 40°C .
Charger Battery Pack
Model FFCL20-02 FFBL2040