Dongcheng ADZC22, Руководство по эксплуатации

Страница: 10 / 80

10
EN
button), and align the triangle symbol with the
as shown in the figure, then the tool is set in drill
operation. Set like this when drilling on the wood,
metal, or plastic, and use twist bits or solid center
bits.
1
2
1.Operating
Mode Selector
2.Lock Button
2.Electric Hammer Mode
Turn the operating mode selector (pressing the lock
button), and align the triangle symbol with the
as shown in the figure, then the tool is set in hammer
operation. Set like this when drilling on the concrete
or stone with a carbide-tipped bit.
1
2
1.Lock Button
2.Operating Mode
Selector
3.Hammer Mode
Turn the operating mode selector (pressing the lock
button), and align the triangle symbol with the
as shown in the figure, then the tool is set in hammer
operation. It can be used for chiseling, stripping,
dismantling and other operations, which require the
use of a pointed drill, chise, rust chisel.
1
2
1.Operating
Mode Selector
2.Lock Button
CAUTION:
Only after the machine shut down can you change
the operation function, otherwise it will damage the
machine.
In order to avoid fast wear of the mode changing
mechanism, it is necessary to ensure that the
operating mode selector is always in one of the three
modes correctly.
When switch from drill mode or hammer mode to
impact mode. The operating mode selector may
not be successful. At this time, press the switch to
inching the machine and then rotate the function
button. Forcing the operating mode selector to rotate
may damage the machine.
● Drill Point Adjustment
When the machine is in hammer mode and the drill
point needs to be changed, press the lock button
and turn the operating mode selector to make the
aimed at , at this point the bit can be adjusted to
the desired angle. Adjust the angle before turning the
machine back into hammer mode.
1
2
1.Lock Button
2.Operating Mode
Selector
● Usage of depth gauge
The installation of the depth gauge is shown in the
figure.
1.Loosen the wing bolt, and insert the depth gauge
into the fitting hole of the clip board.
2.Move the depth gauge to the desired depth and
secure it by rotating the wing bolt clockwise.
1
2
1.Wing Bolt
2.Depth Gauge
● Drill Operation
1.Hammer Drill Operation
Set the operating mode selector to the hammer
mode symbol, and position the bit at the desired
location for the hole, then pull the switch trigger.
CAUTION:
Applying more pressure will not speed up
the drilling. In fact, this excessive pressure
will damage the drill bit, decrease the tool
performance, and shorten the service life of the
tool.
There is a tremendous force exerted on the bit
at the time of hole break through. Be careful and
hold the tool firmly when the bit begins to break
through the workpiece.