Dongcheng ADJF22, Руководство по эксплуатации

Страница: 9 / 44

9
EN
2
1
1.Battery Pack
Button
2.Battery Pack
● Electric Quantity Indicator Light
When the power button is pressed or the tool is
started, the electric quantity indicator light will display
the electric quantity of the battery pack. The electric
quantity level can be displayed by the state of 4 LED
lights (hereinafter referred to as the red light).
1
1.Electric Quantity
Indicator Light
The battery status is shown in the table below
：
Status of Red LED Lights
Approx. Battery
Power Left
4 lights lit 75%~100%
3 lights lit 50%~75%
2 lights lit 25%~50%
1 light lit 10%~25%
● Continuous Use
When you continue to use the machine until the
battery is exhausted, let the machine cool for 15
minutes before replacing it with a new battery pack.
● Over-discharge Protection
The machine is equipped with an over-discharge
protection circuit. When the battery power is
insufficient, the protection circuit is opened and the
machine stops rotating.
● Disposal of used battery packs
To protect natural resources, please recycle or
dispose of battery packs properly. The battery contains
a lithium battery. Please consult the relevant local
authorities for information on recycling and/or disposal.
After the battery pack is exhausted, remove the battery
pack and wrap the terminals with strong tape to avoid
short circuit and leakage. It is absolutely forbidden to
try to open or disassemble any parts or components.
●
Inserting/Replacing Saw Blade
1.Selecting Saw Blade
Use only saw blades suitable for the material being
worked. Select a suitable saw blade according to the
workpiece in reference to the table as mentioned in
intended use. The saw blade should not be longer
than required for the intended cut. Use a thin saw
blade for narrow curve cuts.
2.Inserting Saw Blade
Turn the locking sleeve approx. 90° in the direction of
the arrow and hold it. Insert the saw blade into the saw
blade holder.
CAUTION
：
Check the tight seating of the saw
blade. A loose saw blade can fall out and lead to
injuries.
For some special work, the saw blade can also be
turned through 180° (with the teeth pointed upwards)
and re-inserted again.
3
1
2
3.Inserting
Saw Blade
3. Removing Saw Blade
Turn the locking sleeve for saw blade approx. 90° in
the direction of the arrow and hold it. Remove the saw
blade.
Cautions:
1.Before installing or removing saw blades or any
maintenance work for power tools, be sure to take
out the battery pack.
2.Wear work gloves when installing the saw blade.
If your hands touch the saw blade, you may get
cuts.
3.When replacing the saw blade, please note that
there can be no debris on the saw blade joint,
such as wood chips or metal chips.
3
2
1
3.Removing Saw
Blade