Page 10/11
22. Place the Princeton Section in its preferred nal location in the room.
23. Align the Bunk Bed section with the Princeton Section.
24. Slide the Bunk Bed Inner End Panel up to and ush with the Princeton Section.
25. Align the 3-holes vertically along the Rear Inside Panel Corner Posts ( ushed together).
26. Insert Machine Screw (7) through the two posts and into the Female Hex Nut (8).
27. Tighten with the Allen Key (4) provided.
28. Repeat all steps with the holes vertically along the Front Inside Panel Corner Post ( ushed together).
29. Install the Slat Roll (L) in the Upper Bunk Bed by rolling it out into position on the Support Cleat.
30. Align the outside edge of the rst slat with the end of the Support Cleat on the Inside of the Mattress Support Rail (I).
This aligns the rst slat at the proper distance from the Bunk End Panel.
31. The outside edge of the last slat should be ush with the end of the Mattress Rail Support Cleat at the other end of the
Mattress Rail as well.
32. Insert the Wood Screw (10) into the holes in the slats and tighten.
33. Repeat all steps for the Slat Roll (L) in the Lower Bunk Bed.
Back side
7
8 4
4
7
8 4
4
ASSEMBLY INSTRUCTIONS
# 9018 ARTESIAN STAIR BUNK
