Donaldson Torit DFO 2-4, Инструкция по установке и эксплуатации

Страница: 10 / 44

7
Donaldson Company, Inc.
Standard Equipment
Standard equipment consists of a collector cabinet,
hopper, and legs. Basic assembly starts by attaching
the hopper to the cabinet, then attaching the legs. A
detailed instruction drawing, shipped with each collector,
provides specific assembly and lifting instructions.
Hopper Assembly
Assemble the standard or the optional steep-sided
hopper following these instructions.
1. Stand the hopper on the discharge end.
2. Apply 1/4-in diameter rope-type sealant around the
top flange toward the inside edge
of the bolt pattern.
3. Lift the collector and position over the hopper and
lower slowly.
4. Use drift pins to align holes.
5. Secure collector to hopper using
3/8-16 x 1 1/4-in bolts, flat washers, and nuts. Tighten
all hardware securely. See Hopper Installation
below.
hopper
3/8-16 x 1 1/4-in bolt
3/8-in flat washer
3/8-in flat washer
3/8-in lock washer
3/8-16 hex nut
1/4-in rope-type sealant
Hopper Installation