INSTALLATION MANUAL
EN
- Connect the spotlights to the adaptor following the wiring
diagram:
-
TLD (fig.3)
(touch-led dimmer)
-
TLDM: (fig.4)
(touch-led dimmer master)
-
SLAVE:
(fig.5)
(without switch)
using the extensions provided in the pack (D).
- A connection can be put between the male/female
connectors in the space created by the spotlight between
the installation surface and wall (fig. 6-7).
- Connect the feeder plug (E) to an AC outlet (230V 50/60Hz)
(fig. 3,4,5).
- Connect the device power cable to an appropriate (check
plate data printed on the product label) safe power supply
with stabilised voltage (not included) with power 10% higher
than the total load.
- If more than one device must be connected to the power
supply ensure that the total sum of the power absorbed by
the devices (check the plate data shown on the product
label) does not exceed the maximum power permitted by
the Converter.
- DOMUS Line guarantees the product only if powered with a
Converter supplied by us.
WARNING:
make sure that the environmental conditions in
which the device is to be installed are suitable.
OPERATION:
The appliance is turned on and off simply by rapidly touching
the TLD sensitive switch (C), while a prolonged touch adjusts
the light intensity by increasing or decreasing it.
¹ This installation manual contains instructions valid for all
configurations of the SKATE device
WARNING:
Safety is guaranteed if these instructions are followed and
therefore they must be kept. Installation may require the
involvement of qualified personnel. Before proceeding with
installation of the device ensure that the environmental
conditions are in compliance with and suitable for the
product characteristics. Before any operation on the device
disconnect mains power.
CONFIGURATION:
Instructions for installation and use contained in this manual
are valid for several configurations of the
SKATE
device, for
which there are differences. The
SKATE TLD
(Touch-LED-
Dimmer) model refers to the configuration of the device that
includes a dimmable electronic switch, the skate model refers
to the configuration of the device that does not incorporate
any switch or sensor.
INSTALLATION:
- Fasten the bracket (A), using the screws in the pack (B), on
the installation surface in the position wanted. To install the
fixture correctly, fasten the bracket (A) so it is against the
wall and at right angles to it (fig. 1-2).
- The parts of the installation and use manual common to all
models relate to the
SKATE
model, or the configuration of
the device that does not incorporate a switch or sensor.
