DOMUS LINE 8027934272183, Руководство по установке

Страница: 7 / 10

INSTALLATION MANUAL EN
- Use 24Vdc constant voltage power suppliers only with power
exceeding the total load by at least 10%.
X-SIGN TDM can guide a
maximum load of 50W @ 24Vdc, thus a maximum 5 X-SIGN .
OPERATION:
X-SIGN TDM
and X-SIGN 4F TDM refer to configurations of the
equipment integrating a dimmable electronic switch (D) which enables
switching on, switching off and adjusting light intensity. As indicated in
the INSTALLATION section, these can be installed alone or combined
with
X-SIGN or with X-SIGN 4F (switch-less equipment) to enable
switching on, switching off and adjusting all equipment simultaneously.
The apparatus can be easily switched on and off by touching the switch
(D).
Extended touching of the switch enables adjusting the light intensity
increasing or reducing it. A brief blinking of the equipment indicates
that maximum brightness has been reached.
The brightness level will be memorised until the next adjustment.
WARNING
- The LED module and the power supply cable of this equipment cannot
be replaced,
thus, the entire equipment must be replaced in case of failure.
WARRANTY:
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty’s general terms and conditions
for this device are available at
www.domusline.com
WARNING:
Safety is guaranteed if these instructions are followed and therefore
they must be kept. Installation may require the involvement of qualified
personnel. Before proceeding with installation of the device ensure that
the environmental conditions are in compliance with and suitable for
the product characteristics. Before any operation on the device
disconnect mains power.
INTRODUCTION:
X-SIGN TDM
is a light equipped with an electronic switch (D) wired in
MASTER version. It can be installed alone or combined with X-SIGN
SLAVE (without switch) to enable switching on, switching off and
simultaneous adjustment of all equipment (max. 6 in all).
INSTALLATION:
- Use the drilling template (E) for the correct positioning of the
equipment
- Position the drilling template at the rear part of the hanging elements
and drill the indicated holes (
X-SIGN : 4 ø3mm holes + 1 ø9mm hole for
the exit of the cable or X-SIGN 4F : 5 ø3mm holes + 1 ø9mm hole for the
exit of the cable) see figures 1 and 2.
- Fix the bracket (A) using the screws (B) in the packaging.
- Thus couple the light (B) by matching the hooks present in the bracket
with the relative holes on the light and thus pressure-couple it.
- Electrically connect the lights to the power supply complying with the
wiring diagram (fig. 3,4,5,6) using the extensions (C) provided in the
packaging if necessary.
- Connect the power supply plug (F) to an alternating current socket
(230V 50/60Hz).