Revision: 1.0
Sapphire-BTX Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 4-10
4. LED Display Control
4.1 Power
The Sapphire-BTX can be powered by two sources:
Via a battery – AB or V mount depending on the device battery plate
Via 9-36VDC input to the 6-way Hirose (male) power connector
The power switch should be used to control power to the device (see
Section 3.4
). When the power is
switched on, the power LED will be illuminated (see
Section 3.5
) and the unit will boot up.
4.2 Introduction
Some product features are licensed and may not be available for selection. See
Section 2.5
options.
The Sapphire-BTX has an LED display and control buttons which can be used to monitor and
configure the BTX without the need to connect to a PC device.
When the unit has fully booted, the LED display will show the status screen.
The display will go to sleep and display a blank screen after approximately 30s of inactivity.