Dominator GDO-7v2, Руководство по установке

Страница: 20 / 32

20
GDO-7v2
Owner Installation Instructions
Coding Transmitters
Step 19.1 - Code a Transmitter Button for
Door Operation
Press and hold the DOOR CODE button (Fig. 27) .
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE BUTTON.
Press the transmitter button to test.
Step 19.2 - Coding a Transmitter Button to
the Courtesy Light
The transmitter can be programmed to operate the
courtesy light on the opener independently of the door
moving.
Press and hold LIGHT CODE button (Fig. 28) .
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the LIGHT CODE button.
Press the transmitter button to test.
Step 19.3 - Code a Transmitter Button for Pet
(Pedestrian) Mode
Step 19.4 - Code a Transmitter Button to
Enable Vacation mode
The opener can be programmed into a “Vacation Mode”
where the opener will not respond to any transmitter
except one pre-programmed unit.
a.
b.
c.
d.
a.
b.
c.
d.
27 fi g
28 fi g
29 fi g
Briefly press the DOOR CODE button three times,
then press it again and hold (will beep four times
on fourth press
(Fig. 29)
)
.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE button.
Press the transmitter button to test. To change the
default pet (pedestrian) door opening position,
refer Step 2.
a.
b.
c.
d.
Briefly press the DOOR CODE button once, then
press it again and hold (will beep two times on
second press
(Fig. 29) ) .
Press one of the four buttons on the transmitter for two (2) seconds, pause for two (2) seconds, then press the same
button again for two (2) seconds.
Release DOOR CODE button.
To test, press and hold the transmitter button for seven (7) seconds to set Vacation Mode.
To reset Vacation Mode press the same button for two seconds.
a.
b.
c.
d.
e.
Step 19.5 - Code a Transmitter Button to Enable AUX OUTPUT
Briefly press the DOOR CODE button two times, then press it again and hold (will beep three times on third
press (Fig.29) ).
Press one of the four buttons on the transmitter for two (2) seconds, pause for two seconds, then press the same
button again for two (2) second.
Release the DOOR CODE button.
Press the transmitter button to test.
a.
b.
c.
d.