Dominator GDO-7v2, Руководство по установке

Страница: 17 / 32

Owner Installation Instructions Dominator ® 17
Setting Limits: via Transmitter
22
fi g
The GDO-7v2 has the unique ability to set travel limits
using the transmitter, allowing the installer to move
around the garage and door to better assess the desired
close and open limit positions.
Step 16.1 - Power Up and Set the Datum
Follow Steps 15.1 to 15.3 as outlined overleaf.
Observe all warnings!
Step 16.2 - Code a Transmitter for Limit Setting
Press and hold the DOOR CODE button (Fig. 22).
Press Button 1 on the transmitter for two seconds
(Fig. 23)
. Release and pause for two seconds.
Press the same button again on the transmitter
for two seconds.
Release the DOOR CODE button.
Step 16.3 - Setting Limits via Transmitter
Press and hold Button 4 on the transmitter to close
the door. When the door is approx. 2cm from the
ground, press and hold Button 3 for two seconds
and release
(Fig. 23) .
Each press of Button 4 will allow you to “inch” the
door closed. Keep doing this until the door reaches
the desired close limit position.
If the door is closed too far, press Button 1
to “inch” the door towards open
When happy with the close limit position, press
Button 2 to store this in memory.
Press Button 1 to open the door. When approx.
2cm from the desired open position, press and hold
Button 3 for two seconds then release.
Each press of Button 1 will allow you to “inch” the
door open. Keep doing this until the door reaches
the desired open limit position.
If the door is opened too far, press Button
4 to “inch” the door towards closed
IMPORTANT WARNING: The door will
automatically close, open and close again once
Step 16.3(f) is performed . Ensure that no persons
or objects are in the door’s path.
When happy with the open limit position, press
Button 2 on the transmitter to store into memory.
The door will now automatically close and open to
calculate the safety obstruction settings. After this, the
opener can be operated with the OPERATE button.
Step 16.4 - Resetting the Door Limit Positions
Limit positions can be deleted by the following steps:
Follow Steps 15.5 (a) and (b), as outlined overleaf.
Repeat Steps 16.1 and 16.3 to set new travel limit
positions.
There is no need to re-code the transmitter
(Step 16.2) upon restting travel limits. The
transmitter will still be stored in memory.
a.
a.
b.
c.
a.
b.
»
c.
d.
e.
»
f.
g.
a.
b.
»
Button 1
(Inch Open)
Button 4
(Inch Close)
Button 2
(Set)
Button 3 (
Switch between
fast and slow
inching)
23 fi g