Dometic Waeco PerfectView VT100DIG, Инструкция по установке и эксплуатации

Страница: 25 / 200

VT100DIG Installing the radio link
EN 25
6 Installing the radio link
6.1 Tools required
For installation and assembly, you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection, the following tools are required:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Crimping tool (fig. 1 10, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To fasten the module and the cables, you may need additional screws and cable
binders.
6.2 Installing the modules
!
CAUTION!
Select the location of the modules so that they cannot injure the passengers in
the vehicle under any circumstances (e.g. sudden braking, road traffic acci-
dents).
Observe the following installation instructions:
 Install the modules so that as few objects as possible are between them.
Metal objects in particular can hinder radio transmission.
 If possible, install the modules in the vehicle.
The housings are splash-water protected and can be mounted outside the vehicle. In
this case, you need to select a location that is protected against mechanical impacts
(e.g. flying stones).
 The installation location should be flat.
 Before drilling, check each time that there is sufficient space on the other side for the
drill head to emerge (fig.
2 , page 4).