CoolFun MB40
Cleaning and maintenance
23
7
Cleaning and maintenance
!
WARNING!
Always disconnect the device from the mains before you clean and
service it.
A
NOTICE! Risk of damage!
z
Do not clean the cooler under running water or in dish water.
z
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooler.
➤
Occasionally clean the device interior and exterior with a damp cloth.
8
Troubleshooting
Fault
Possible cause
Suggested remedy
Your cooler does not func-
tion (plug is inserted).
There is no voltage
present in the 12 V
socket (cigarette
lighter) in your vehicle.
The ignition must be switched on in
most vehicles for voltage to flow at the
cigarette lighter.
No voltage present in
the AC voltage socket.
Try using another plug socket.
The inner fan or the
cooling element is
defective.
This can only be repaired by an author-
ised customer services unit.
When operating from the
12 V socket (cigarette
lighter):
The ignition is on and the
cooler is not working.
The fitting of the 12 V
plug is dirty. This
results in a poor elec-
trical contact.
If the plug of your cooler becomes very
warm in the 12 V socket fitting, either
the fitting must be cleaned or the plug
has not been assembled correctly.
The fuse of the 12 V
plug has blown.
Replace the fuse (5 A) in the 12 V plug
(fig.
4
1, page 4).
The vehicle fuse has
blown.
Replace the vehicle's 12 V socket fuse
(usually 15 A). Please refer to the oper-
ating manual of your vehicle.
No music.
The batteries are
empty.
Insert three new 1.5 V batteries,
type AA (Mignon).
_MB40.book Seite 23 Donnerstag, 2. Dezember 2010 3:52 15
