3
B. Assembly
1. Install joiner tubes as shown in Fig. 1. Use screws
provided.
Note: Start all screws into holes before tightening nuts. Do not
overtighten nuts.
2.
Unroll awning fabric on a flat, clean surface. Insert
awning fabric into front bar with the white side up. See
Fig. 2.
3.
With front bar on fabric, roll awning up into bag and zip
bag closed.
LOCKNUT
SCREW
CONNECTOR
JOINT
FLAT
WASHER
C. Installation
1.
Prepare the awning rail to accept the Trimline awning
by opening the lead end of the awning rail with a
screwdriver as shown in Fig. 3.
a.
Install vinyl welt of awning bag into
awning rail by inserting vinyl welt into
one end of awning rail and sliding
awning into position. See Fig. 4.
b.
If the awning is to be left mounted
during travel, secure each end by
installing a #6 x 1/2" drill point screw
in each end. See Fig. 4
Note: When unzipping bag or untying
poles, be sure to hold poles so loose poles
do not fall out of bag.
3.
Install top pair of sockets with #8 x 3/4" sheet metal
screws at each end of awning directly under awning
rail. Make sure large groove on socket faces down.
Align socket directly under Hook & Loop Fastener
tape or zipper, depending on model. See Fig. 5.
4.
Install bottom pair of sockets with #8 x 3/4" sheet
metal screws at each end of awning below camper top
when camper is in open position (approx. between 49"
to 52" below awning rail). Large groove on socket
should face up. It is very important to keep the bottom
pair of sockets out of the way of the camper top when
closing camper. See Fig. 5.
A&E Trim Line Awning Installation & Operating Instructions
A. Application
The A&E Trim Line Awning is designed and intended for
mounting on pop-up tent campers.
Important:
Read the entire installation procedure be-
fore starting the installation.
Note: Dometic Corporation assumes no liability for damages
or injury resulting from installation or operation of this product.
FIG. 4 (Option)
Vinyl Welt
Screw
FIG. 2
After
FIG. 3
Awning Rail
FIG. 5
Before
FIG. 1
SOCKET
AWNING
FABRIC
AWNING
RAIL
HOOK & LOOP
FASTENER OR ZIPPER
LARGE GROOVE
DOWN
SOCKET
LARGE GROOVE
UP
APPROX.
49”-52”
