4
D. Operation
1.
Unzip awning bag and untie webbing straps. Unroll
awning fabric.
2.
Unfold ground legs from lead rail. Extend middle and
lower tube (7'-9' models) or lower tube (10'-13' models)
to desired height. Hold tube nearest lead rail and
locate alignment marks on tubes. See Fig. 6. Align-
ment marks for 7'-9' models are located on middle and
lower tubes. For 10'-13' models, alignment marks are
located on top and lower tubes. Align mark on lower
tube with mark on middle tube (for 7'-9' models) or with
top tube (for 10'-13' models). Push lock button in and
slide lower tube into mating tube to lock push button
in desired hole. Repeat with middle tube and top tube
for 7'-9' models. Top tube has 4 locking positions,
each 5" inches apart from each other to adjust to
desired height.
3.
Unfold rafter poles and extend them into socket under
awning rail. Hold tube nearest lead rail and twist
middle and lower tube (7'-9' models) or lower tube (10'-
13' models) to lock. See Fig. 6.
4.
Ground poles can be placed upright in carport position
or they can be inserted into sockets (previously
installed on camper) up against camper for a patio
position awning. Galvanized steel tent stakes and
wire loops for tent stakes are provided to position
ground poles upright and hold them in the ground. See
Fig. 7. Use spare sockets provided to attach to end
balls on ground poles to protect end ball when staking
poles to ground. Drive stakes into ground capturing
stake wire with tent stake. See Fig. 7. To position
awning in patio position, extend ground poles and
insert bottom end balls into sockets previously in-
stalled on camper wall above frame. See Fig. 8.
FIG. 6
FIG. 7
FIG. 8
A&E Trim Line Awning Installation & Operating Instructions
Camper Wall
Ground Pole
Socket
5.
To close awning, reverse Steps 1 through 4.
Note: During rain, awning should be closed or lowered on one
end to allow water to run off.
6.
After rolling awning up, use tie strap to hold awning
securely inside bag. Zip the bag closed for travel.
TENT
STAKE
WIRE LOOP
GROUND
POLE
RAFTER
POLE
LEAD RAIL
HOLD
TWIST
TO LOCK
TWIST
TO LOCK
SNAP BUTTON IN
HOLE TO LOCK
GROUND
LEG
SNAP BUTTON IN
HOLE TO LOCK
