20
Refrigerator operation
5.14 Trouble-shooting
Failure: The refrigerator does not cool sufficiently.
-
Inadequate ventilation to the unit.
-
Thermostat setting is too low.
-
The condenser is heavily frosted.
-
Too much warm food has been stored inside
within short period of time.
-
The appliance has been running for only a short
period of time.
-
Ambient temperatures too high.
-
Check that the ventilation grille of the cooling
unit is not covered.
-
Set thermostat to a higher level.
-
Check that the refrigerator door closes properly.
-
Allow warm food to cool down before storage.
-
Check whether the cooling compartment works
after approx. 4 - 5 hours.
-
Ventilate room.
Possible cause
Action you can take
Failure: The refrigerator does not cool in gas operation mode.
- Gas cylinder empty.
- Is the upstream shut-off device open ?
-
Air in the gas pipe ?
-
Change gas cylinder.
-
Open shut-off device.
-
Switch off the appliance and start again. Repeat
this procedure 3 - 4 times, if necessary
Possible cause
Action you can take
Failure: The refrigerator does not cool in 230V operation.
-
On-board fuse defective.
-
No connection to mains supply voltage.
-
Heating element defective.
-
Fit new fuse.
-
Make a connection to a mains power supply.
-
Please inform the Dometic Customer Service.
Possible cause
Action you can take
Before notifying the authorised Service Center,
please check whether:
n
the instructions in section "Operating the
refrigerator" have been observed.
n
the refrigerator stands level.
n
it is possible to operate the refrigerator with
any available power source.
289 0317-60_2_EN_RGE3000_N1_Layout 1 13.02.2013 09:56 Seite 20
Содержание RGE 3000
Страница 103: ...5 15 Schablone Template Bijlage Gabarit Sagoma Plantilla Anhang Annex e Bijlage Appendice Apéndice 1 1 Left Right ...
Страница 104: ......
Страница 105: ......