Dometic PR4500, Руководство по эксплуатации

Страница: 19 / 180

EN
PR4500 Adjusting the awning
19
Step 2: Programme the wind sensor
➤
Turn the knob for setting the sensitivity (fig.
6
2, page 4) to “0”.
➤
Press the programming button in the battery compartment of the remote control
(fig.
3
2, page 3).
✓
The receiver beeps once briefly.
✓
The awning moves twice briefly.
➤
Press the programming button directly afterwards in the battery compartment of
the remote control (fig.
3
2, page 3).
✓
The receiver beeps once briefly.
➤
Press the programming button on the wind sensor (fig.
6
1, page 4) once
briefly.
✓
The sensor beeps once briefly.
✓
The awning moves twice briefly.
✓
The receiver beeps five times briefly.
✓
The wind sensor is now linked to the awning.
➤
Turn the knob for setting the sensitivity (fig.
6
2, page 4) to “3”.
Step 3: Insert the wind sensor and sensor unit and check the sensor
➤
Insert the sensor unit in the housing.
➤
Install the wind sensor on the inside of the front panel.
➤
Test the wind sensor by moving the front panel approx. 10 cm up and down
quickly in the middle for 8 seconds (fig.
4
, page 3).
✓
The awning retracts.
The wind sensor is correctly programmed and the procedure is complete.
➤
If the awning fails to retract, repeat the programming.
PR4500-O-West-South.book Seite 19 Mittwoch, 5. Oktober 2016 1:08 13