EN
Troubleshooting
PR4500
26
The motor is not
responding to the
remote control.
The switch-on delay is
active.
If the awning has been
retracted automatically
by the wind sensor, it can
only be extended again
after 60 seconds.
Wait for this time to elapse or switch
the power supply to the awning off and
on again to bypass the switch-on delay.
Only extend again, if the wind is not
present any more.
The remote control
battery is flat.
Briefly press the
or
button. If
the remote control LED does not light
up, the battery is flat.
Replace the battery (see chapter
“Changing the battery in the remote
control” on page 15).
The remote control is not
properly set to the
motor.
Reset the motor and the remote
control, see chapter “Resetting the
motor and remote control” on
page 20.
No power supply
available.
Check the electrical connections.
The motor is defective.
Retract the awning manually, see
chapter “Closing the awning manually
in emergencies” on page 17, and
contact the service partner in the
respective country.
Awning does not fully
extend or extends too
far (fabric sags at ends).
The outer limit is not
properly set.
Reset the outer limit, see chapter
“Resetting the outer limit” on page 18.
Problem
Possible cause
Suggested remedy
PR4500-O-West-South.book Seite 26 Mittwoch, 5. Oktober 2016 1:08 13
Содержание PR4500
