Dometic PERFECTVIEW CAM60ADR, Инструкция по установке и эксплуатации

Страница: 14 / 188

Mounting the camera CAM 60ADR
EN
14
•
When laying electric connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (fig.
3
, page 4)
•
Attach the cables securely in the vehicles to prevent tripping hazards. Use cable binders,
insulating tape or glue the cables in place.
•
Protect every through-hole made in the bodywork against water penetration, e.g. by using a
cable with a sealant and by spraying the cable and the the cable sleeve with sealant.
I
8 Mounting the camera
8.1 Tools required
For installation and assembly you will require the following tools:
•
Drill bit set (fig.
1
1, page 3)
•
Drill (fig.
1
2, page 3)
•
Screwdriver (fig.
1
3, page 3)
•
Set of ring or open-ended spanners (fig.
1
4, page 3)
•
Measuring ruler (fig.
1
5, page 3)
•
Hammer (fig.
1
6, page 3)
•
Centre punch (fig.
1
7, page 3)
To make and test the electrical connection , the following tools are required:
•
Diode test lamp (fig.
1
8, page 3) or voltmeter (fig.
1
9, page 3)
•
Insulating tape (fig.
1
11, page 3)
•
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
NOTE
Do not start sealing the through-holes until all installation work has been finished for the
camera, and the required cable lengths have been established.
CAM60ADR-IO-16s.book Seite 14 Donnerstag, 7. Juli 2016 1:21 13