Dometic PerfectView CAM360, Руководство по установке

Страница: 26 / 452

EN
Connecting the video system CAM360
26
9 Connecting the video system
A
I
➤
Connect the video system as shown in the connection diagram (fig.
c
, page 7).
➤
Insulate the plug of the camera adapter cable with the included vulcanising adhe-
sive tape (fig.
i
, page 9).
Key for the connection diagram
NOTICE!
•
The lines for terminal 15, left indicator, right indicator and reverse
must be secured on the vehicle side with a fuse rated no higher than
3 A. If this is not the case, then an additional fuse must be used at the
corresponding consumer point.
•
If the connection
“MONITOR CTRL OUT” is not used, the copper end must
be insulated. The load of this output must not exceed 150 mA.
NOTE
Lay the camera cable so that, should you need to remove the camera,
you can access the plug connection between the camera and the exten-
sion cable easily.
No. in
fig.
c
,
page 7
Description of the connection
1 Monitor
2 Cameras
3 DC-DC converter
4 Controller
5 USB input
6 Black plug: Infrared receiver for the remote control
7 Yellow plug: Video output
8 Black plug (“FRONT”): Front camera
9 Black plug (“LEFT”): Left camera
10 Black plug (“RIGHT”): Right camera
11 Black plug (“REAR”): Rear camera
12 Slot for SD card
CAM360-I-DE.book Seite 26 Freitag, 9. Juni 2017 6:50 18