Dometic DC-Kit5, Руководство по эксплуатации

Страница: 21 / 292

EN
DC-Kit5 Using the DC kit
21
A
8.1 Switching on the system
Observe the following instructions before you switch on the system:
•
Air the vehicle.
•
Make sure that the ventilation slots on the air nozzles and the fan of the
components are not covered up.
•
Make sure that all the housings and cables are not damaged and that all the
insulation is intact.
•
Compare the existing supply voltage with the technical data.
•
Do not insert any fingers or objects into component openings.
I
Stationary mode: 230 V
w
mains operation
The system is supplied with 230 V
w
from the mains. Leave the inverter switched off.
Driving mode: power supply from the 24 V battery
➤
Switch on the inverter using the MCR-9 remote control.
A
➤
Use the roof air conditioner as described in the operating manual.
NOTICE!
CA 2500, B2200, B1600 Plus, HB2500, FJ1100, FJ1700,
FJ2200, FL1600, FL2200, FW3000:
the inverter may be damaged.
If you are operating the system on the 230 V mains and the automatic air
conditioner or the heating is on, make sure that the inverter is switched
off and stays switched off.
The inverter is not designed for the amount of power an active heating
system requires. If the 230 V mains power fails, the inverter would then
take over supplying the power.
NOTE
CA 2500, B2200, B1600 Plus, HB2500, FJ1100, FJ1700,
FJ2200, FL1600, FL2200, FW 3000:
The remote control for the air
conditioner can only be used if the air conditioner is supplied with 230 V
mains network or with the inverter.
NOTICE!
CA 2500, B2200, B1600 Plus, HB2500, FJ1100, FJ1700,
FJ2200, FL1600, FL2200, FW3000:
the inverter may be damaged.
Do not switch on the roof air conditioner in the automatic or heating
modes.
DC-Kit5--IO-16s.book Seite 21 Dienstag, 21. März 2017 2:32 14