Dometic BC100, Руководство по эксплуатации

Страница: 11 / 164

EN
BC100, BC 200 Starting the battery conditioner
11
6 Starting the battery conditioner
A
I
➤
Check that the battery is in good condition.
➤
Check the following:
–
The battery housing for damage
– The fluid level in the battery
If necessary refill the battery with distilled water.
– The pole contacts
Clean off any dirt present.
– Check the battery voltage with a voltmeter: It should not be below 9 V
(MBCC100) or 4.5 V (MBCC200).
If the voltage is less than 9 V (12 V batteries) or 4.5 V (6 V batteries) a cell may
be defective. In such a case, the battery is defective and may
not be
recharged.
➤
Switch the vehicle ignition off.
➤
Plug the charging plug (fig.
2
1, page 3) of the battery conditioner into the
12/6 V
g
socket (e.g the cigarette lighter) or
➤
… connect the adapter cable (fig.
2
2, page 3) to the battery terminals on the
battery (fig.
2
3, page 3):
– Positive terminal of the battery: red cable
– Negative terminal of the battery: black cable
I
➤
Plug the power cable of the battery conditioner into a 230 V/50 Hz socket.
NOTICE!
Set up the device in a location where it is protected against moisture and
moist air.
Ensure that
•
The installation location is well ventilated and
•
The mounting surface is flat and sufficiently firm.
NOTE
On some vehicles, the 12/6 V socket only works when the ignition is
switched on.
In this case, connect the battery conditioner direct to the battery.
NOTE
If the red “Incorrect Polarity” LED (fig.
1
5, page 3) glows when con-
necting to the 12/6 V
g
socket, you need to connect the device directly
to the battery using the adapter cable (fig.
2
2, page 3).
MBCC-100-200--O-16s.book Seite 11 Montag, 21. November 2016 10:01 22