Dometic ACX35, Руководство по эксплуатации

Страница: 24 / 284

EN
Troubleshooting ACX35, ACX40, ACX40G
24
9 Troubleshooting
Problem Possible cause Suggested remedy
The cooler does not
work. The cooler has not been
set up properly. Check if the device is horizontal.
Check if the ventilation of the device is
sufficient.
The refrigerant circuit is
defective. This can only be repaired by an
authorised repair centre.
IN DC mode:
The cooler is not
working (plug is
inserted). No voltage is flowing
from the DC power
socket in your vehicle. The ignition must be switched on in
most vehicles to supply current to the
DC power socket.
The DC socket is dirty.
This results in a poor
electrical contact. If the plug of your cooler becomes
very warm in the DC socket, either the
socket must be cleaned or the plug
has not been assembled correctly.
The fuse of the DC plug
has blown. Replace the fuse of the DC plug
(fig.
6
1, page 7) with one of the
same rating.
The vehicle fuse has
blown. Replace the vehicle fuse in the DC
socket (usually 15 A) (Please refer to
the operating manual of your vehicle).
In AC mode:
The cooler is not work-
ing (plug is inserted). No voltage present in
the AC socket. Try using another plug socket.
In gas mode:
The cooler is not
working (to cooler is
connected to the gas). The cooler is not
properly connected to
the gas. Check if the gas supply is in full
working order.
Check if the valve on the gas bottle is
open.
Check if there is still gas in the bottle.
Check if several energy sources are
connected at the same time.
Hold down the temperature controller
longer to ignite the flame.
The cooler does not start
up after a long period of
inactivity. – Disconnect the device from the power
supply, turn it upside down and wait
for five minutes.
Turn the cooler the right way up again
and switch it on again.
ACX35-ACX40-ACX40G-O-15s.book Seite 24 Freitag, 22. September 2017 6:24 18