Dometic 9600003262, Инструкция по установке и эксплуатации

Страница: 10 / 184

Safety and installation instructions VT50WiFi
EN
10
If you disconnect the negative terminal of the battery, all data stored in the volatile memories will
be lost.
•
The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating instructions.
Observe the following installation instructions:
!
CAUTION!
•
Secure the parts installed in the vehicle in such a way that they cannot become loose
under any circumstances (sudden braking, accidents) and cause
injuries to the
occupants of the vehicle.
•
Secure any parts of the system covered by the bodywork in such a manner that they
cannot be come loose or damage other parts and cables or impair vehicle functions
(steering, pedals, etc).
•
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only be
performed by qualified specialists.
A
NOTICE!
•
To prevent damage when drilling, make sure there is sufficient space on the other
side for the drill head to come out.
•
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
A
NOTICE!
•
When testing the voltage in electrical cables, only use a diode test lamp or a
voltmeter.
Test lamps with an illuminant take up voltages which are too high and which can
damage the vehicle's electronic system.
•
When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
•
Insulate all connections.
•
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
VT50WiFi-IO-16s.book Seite 10 Freitag, 30. Juni 2017 11:04 11