14
TROUBLESHOOTING
B. Vibration Sensor
PROBLEM
CAUSE
SOLUTION
Awning does not
automatically close when
windy conditions are
present.
Vibration sensor batteries are low.
Replace batteries. See Section “B. Changing The
Batteries In The Vibration Sensor” on page 11.
Vibration sensor is not programmed to awning
motor.
Program the vibration sensor. See Section “C. Pro-
gramming The Vibration Sensor” on page 5.
Sensitivity setting is too low.
Adjust to appropriate sensitivity level. See Section “A.
Adjusting The Vibration Sensor” on page 9.
Awning automatically clos-
es during light
breezes.
Sensitivity setting is too high.
Awning automatically clos-
es after 30 minutes without
windy conditions.
Vibration sensor batteries are low. This is indi-
cated by the vibration sensor beeping at regular
intervals.
Replace batteries. See Section “B. Changing The
Batteries In The Vibration Sensor” on page 11.
Awning automatically clos-
es after one hour without
windy conditions.
Vibration sensor is missing, or installed incorrectly
on sensor base.
Install vibration sensor onto sensor base correctly.
See vibration sensor instructions on how to replace
the vibration sensor.
Vibration sensor batteries are dead.
Replace batteries. See Section “B. Changing The
Batteries In The Vibration Sensor” on page 11.
Vibration sensor is damaged or defective.
Replace vibration sensor. See vibration sensor
instructions on how to replace the vibration sensor.
Vibration sensor does not
beep when new batteries
are installed.
Vibration sensor batteries are installed incorrectly.
Install batteries to correct polarity (direction).
