PATTY O’ ROOM
TM
7
MEASURE DOWN
FROM TOP OF SKIRT
TO LOWEST PART OF
STEP
FIG. 10
SIDE PANEL POSITIONS
WHEEL WELL
SKIRTS
VEHICLE SKIRT
HOOK &
LOOP
FASTENERS
20. Drill a 1/8” pilot hole for the twist fastener at the right/left
corner of the Patty O’Room. Mark the opposite end of
the fabric to be trimmed 3 to 4 inches past the end of
the Patty O’Room. Square and cut off. Pull the skirt
taut and finish installing the twist fasteners in a straight
line along the bottom of the coach. The remaining cor-
ner (if eyelet is cut off when skirt is cut to length) is held
in place by attaching the 1x3” hook and loop fasteners
supplied in the kit.
Skirting must not interfere with appliance
venting. Do not start or operate motor home
engine or RV generator if exhaust vents are
located behind skirting. Death or serious
injury from Carbon Monoxide Poisoning
could occur if not operated properly.
21. Locate the step, determine the uppermost part of it by
feeling. Mark the edges of the step on each side. See
FIG. 11.
22. Measure down from the top edge of the skirt to the low-
est part of the step. Add 1/4” to this measurement. Mark
a line for the cut for the step on the skirt fabric. See FIG.
11.
FIG. 11
MARK THE
WIDEST
PART OF
STEP ON
FABRIC
TOP OF
SKIRT
23. Draw the outline for the step flap on the skirt fabric and
cut with scissors. See FIG. 12.
FIG. 12
DRAW LINE AND CUT
FLAP
MARKS FOR THE TOP AND
WIDEST PART OF STEP
MEASURE
DOWN FROM
TOP OF SKIRT
TO LOWEST
PART OF STEP
SKIRT
TOP
24. Tuck flap of skirt behind step to keep out insects.
25. The wheel well skirts are installed in the same way as
the main skirt. They are centered on the wheel well.
Peel the backing of the hook and loop fasteners and
attach to the coach. Two skirts are provided with the
Patty O’Room door and side panel assembly. Both are
used on dual axle, triple axles will require 3 wheel well
skirts. Order additional wheel well skirt part number
3307975.007.
26. Adjust the height of the roller tube so that all panels
hang straight and level. See FIG.’s. 13 & 14.
FIG. 13
CORRECT
FIG. 14
INCORRECT
27. Secure all panels and vehicle skirting by driving the tent
stakes inside the room, through the grommets into the
ground.
TWIST
FASTENERS
