5
INSTALLATION
A. Prepare Hardware Assembly
1.
Select the desired awning rail end (on RV) into
which the awning fabric will be inserted. Widen
that end of the rail with a flat screwdriver, and file
off any sharp edges. See (FIG. 2).
FIG. 2
Before
After
2.
Spray inside of awning rail with silicone spray or
lubricant to ease sliding Dome Awning and skirt
through awning rails.
3.
Carefully slide Dome Awning into awning rail un-
til it is in the desired position.
4. Undo ties to roll fabric assembly out.
B. Assemble Poles And Dome Awning: Flex
Collapsible Pole (1) And Telescoping
Aluminum Poles (3)
1.
Assemble collapsible flex pole. Prepare Dome
Awning for flex pole by unzipping front panel
from the bottom up. Stop approximately at the
buckles. Insert flex pole into sewn-in pocket lo-
cated on front of Dome Awning. Push flex pole
through entire front pocket.
Do
NOT
try to pull flex pole through. Pull-
ing will only disassemble sections of the
flex pole.
FIG. 3
2.
When flex pole is pushed through entire front
pocket, secure (1) pole end into brass grommet
in webbing. See (FIG. 4) & (FIG. 5).
FIG. 4
Brass
Grommet
FIG. 5
Brass Grommet
3.
Buckle the webbing strap on the opposite side.
See (FIG. 6).
FIG. 6
4. Form arch with flex pole and insert other end of
flex pole into brass grommet on webbing. Zip
front panel to ease the next step. With some-
one’s help, hold Dome Awning in place while
telescoping aluminum roof poles are installed
inside Dome Awning. See (FIG. 7).
