7
FIG. 15
3.
Install Vehicle Skirt by sliding skirt through aw-
ning rail previously installed by manufacturer on
RV. Cut mesh skirt where necessary to allow ac-
cess to steps and go over RV axle.
D. Seal Dome Awning And Skirt (Models
747XXXXX.102)
1.
Straighten out fabric and fold bottom flaps to-
wards outside. See (FIG. 13).
2.
Once Dome Awning is in place, suction cup fas-
teners (included) should be installed and fas-
tened to provide a seal between RV and Dome
Awning.
a.
Place hook on suction cup fastener through
grommet (with hook facing out) and pull fab-
ric flap against RV.
b.
Once flap is in correct position against side-
wall, push suction cup, in unlocked position,
onto RV.
c.
Rotate hook to the locked position, securing
suction cup fastener and fabric flap against
wall.
d.
Repeat steps (3 on each side) until fabric
flap is fully secured.
Spare suction cup has been provided
for convenience.
3.
Install Vehicle Skirt by sliding skirt through aw-
ning rail previously installed by manufacturer on
RV. Cut mesh skirt where necessary to allow ac-
cess to steps and go over RV axle.
FIG. 13
2.
Once Dome Awning is in place, snap fast fasten-
ers (included) should be installed and fastened
to provide a seal between RV and Dome Aw-
ning.
a.
Determine location of snap fast fasteners by
pulling fabric flap against RV and marking lo-
cation of grommet centers (3 on each side)
on RV side wall.
b.
Drill 1/8” pilot hole for installation of snap fast
fasteners.
You may drill hole right through fabric
in center of grommets if desired.
c.
Apply polyurethane sealant to the back of
fastener and threads of screw for fastener
before screwing them to the side wall as they
will remain on side wall for future use. Spare
fasteners and screws have been provided
for convenience. See (FIG. 14).
FIG. 14
d.
Fasten snap fast fasteners by pressing on
grommets to allow fastener through. See
(FIG. 15).
INSTALLATION
