13
2.
Connection Of 115 Volt Power Supply
Disconnect 115 volt AC. Failure to follow these
instructions could create a shock hazard
causing death or severe personal injury.
a.
Route power supply line through Romex con-
nector into junction box on side away from the
ceiling template. Tighten connector.
Furnace
Timer
Unit
On
Unit
On
Cool
Heat
Connect The
RJ-11 Plug To
Receiver
FIG. 27
Mount With Two
Screws
Receiver
Point Towards
Rear Or Front
Of Vehicle
This product is equipped with a 3-wire
(grounded) system for protection against
shock hazard. Make sure that the product is
wired into a properly grounded 115 volt AC
circuit and the polarity is correct. Failure to do
so could result in death, personal injury or
damage to the equipment.
b.
Connect white to white; black to black; and
green to green or bare copper wire using appro-
priate sized twist connectors.
c. Tape the twist wire connectors to the supply
wire to assure they don't vibrate off.
d. Push the wires into the box.
e. Install the cover onto the junction box.
I.
Decorative Cover Installation
Installing unit with 3105007.XXX or 3105935.XXX
Return Air Cover. For Genesis Air Filtration Sys-
tem Return Air Kit See Page 14.
Note: On models equipped with a solar panel, see wiring
instructions for the solar panel before proceeding.
1.
Remove the return air grill from the return air cover.
2.
Place the return air cover up to the ceiling tem-
plate.
3.
Install cover to template with #8 x 3/8” blunt point
Phillips head screws provided (6 required).
4.
Reinstall filter return air grill into return air cover.
Align tabs with mating notches and snap into place
5.
Install two hole plugs into screw holes in back of
return air cover. See FIG. 28.
6.
This completes the installation of the air conditioner.
We recommend that power be supplied to the air
conditioner and check for proper operation. Refer to
Operating Manual or User's Guide for a description
of the air conditioner operation.
FIG. 28
Return Air
Cover
Hole
Plugs
Return
Air Grill
620615, 620625 & 620626 Installation & Operating Instructions
