8
EN
Installation
q
w
e
r
8
Applying the Sealant
q
Mounting Bracket
e
Carriage Bolts
w
Sealant
r
Mounting Holes
2. Apply the sealant to the edge of the mounting
bracket and around the drilled holes.
q
w
e
r
tyu
9
Securing the Mounting Bracket to a Non-Solid Structure
q
Carriage Bolt
t
Flat Washer
w
Mounting Bracket
y
Split Lock Washer
e
RV Wall with Non-
Solid Structure
u
Locknut with Nylon
Insert
r
Sleeve
3. Secure the mounting bracket to the RV wall.
4. Torque the carriage bolts to 35 lb in. (±5 lb in.).
5.2 Wiring the Switch
1. Confirm the gas supply is shut off, and the 120 VAC
power from the RV and the positive (+) 12 VDC
terminal from the supply battery are disconnected.
I
The motor wire colors are blue (+) and brown (–).
q
w
e
t
y
r
10
Measuring for Wiring Hole Location (Rear View)
q
Mounting Bracket
r
Wiring Hole
w
Horizontal Distance
t
RH End Cap
e
4.25 in. (108 mm)
y
Back Rail
2. Calculate the horizontal distance: Subtract the
mounting bracket length from the back rail length.
Divide the result by two. Add 0.63 in. (16 mm) to the
result.
I
The distance from the end of the bracket to the
end of the back rail may not be constant.
3. Measure the horizontal distance from the RH (right-
hand) end cap edge of the mounting bracket. Draw
a vertical line.
4. Measure 4.25 in. (108 mm) up from the bottom of
the mounting bracket. Draw a horizontal line.
5. Drill a 5/8 in. hole at the intersection of the
horizontal and vertical lines.
q
w
e
r
11
Routing the Wiring (Rear View)
q
Mounting Bracket
e
Wiring
w
Grommet
r
RV Wall
