Dome DMWD1, Руководство пользователя

Страница: 14 / 17

Page 14
Door/Window Sensor Advanced User Manual
Compatible Command Classes
Command Class Notes
Association V2 (85)
Group 1
Group 1 is the “Lifeline” group, which can hold five members, typically
including the main Z-Wave controller. The Door/Window Sensor sends
this group a Notification Report and a Binary Sensor Report when it is
opened or closed. It also sends this group a Battery Report in reponse
to Battery Get commands.
Group 2
The Door/Window Sensor sends a Basic Set command to Association
Group 2 (or the Control Group) to directly trigger devices (like a light,
chime, etc.) in response to events. Then, after a preset delay, a BASIC_
SET(00) command is sent to reset the device (e.g. turn off the light.) The
value of the Basic Set command (e.g. brightness of the lamp,) and the
delay time before the BASIC_SET(00) is sent is configured using configu -
ration parameters 1 and 2 respectively.
Group 3
Group 3 supports up to 5 members and the Door/Window Sensor sends
it a NOTIFICATION_REPORT when the door either opens or closes.
Group 4
Group 4 supports up to 5 members and the Door/Window Sensor sends
it a SENSOR_BINARY_REPORT when the door either opens or closes.
Wake Up V2 (84)
The wake-up interval is set in seconds, and is 43,200 seconds (12 hours)
by default. The wake-up interval can be set to any value from 300s (5
minutes) to 16,777,200s (about 190 days) in 60-second increments.
Notification V4 (71)
The Door/Window Sensor sends a Notification Report to the main con -
troller whenever the door is opened and closed.
Returned Value: 00 00 00 FF 06 XX 00 00
V1 Alarm Type
: 00
(Unsupported)
V1 Alarm Level : 00
(Unsupported)
Reserved : 00
(Reserved)
Notification Status: FF
(Unsolicited Reporting is Enabled)
Notification Type : 06
(Access Control)
Event :
Door Open —16
(Window/Door is Open)
Door Closed —17
(Window/Door is Closed)
Sequence/Reserved/Event Parameters Length: 00
Notification Event Parameters : 00
(No Event Parameters)
Configuration V1(70) See ““Configuration” Command Class Parameters” on page 15.
Table 5 - Command Classes Continued