domat R560
11/2018 Subject to technical changes.
3
Standards conformity
EMC EN 61000-6-2 ed.3:2005, EN 61000-6-4 ed.2:2006 +
A1:2010 (industrial environment)
Electrical safety EN 60950-1 ed.2:2006 + A11:2009 +
A12:2011 + A1:2010 + A2:2014 + Opr.1:2012 + Z1:2016
Hazardous substances reduction EN 50581:2012
Terminals
Terminals and
connectors:
RS485 K+
port COM1 - serial link RS485, terminals K+
RS485 K-
port COM1 - serial link RS485, terminals K-
G
G power supply
G0
G0 power supply
TE
optional connection for shielding, technical ground
AIC
common terminals for AI1
…A
I8
AI1 … AI8
input 1 … 8
LED indication:
RUN
orange LED
–
system cycle (OK: LED flashes periodically 1
s ON, 1 s OFF; ERROR: LED flashes in other pattern, LED is
still ON or OFF)
TxD
red LED
–
RS485 transmitting data at COM1 (flashing:
transmitting data; OFF: no data traffic)
PWR
green LED
–
power supply (ON: power OK; OFF: no power
applied, weak or damaged power supply, …)
DIP switches:
ADR
AUTO
–
if all switches are OFF, the address is used
according to Modbus register 4 LSB
USER
–
address is set by DIP switches configuration
INIT - if are all switches ON at power-up, configuration
parameters are set to defaults
DIP 8 = bit 0; switches increase their bit weight from
right to left, see below
BUS END
Switch for bus RS485 termination (located at the RS485
connector); ON = bus end; the first and last devices on
bus should have bus end ON
