domat R560
11/2018 Subject to technical changes.
5
Dimensions
Dimensions are in
mm
.
Installation
The R560 module is fixed on standard DIN rail (by snapping).
When removing the module from the DIN rail proceed as follows: Place a
screwdriver in the plastic slot which is in the middle of bottom part of the module
(1). Then push the screwdriver upwards (2). After that, the module can be removed
by tilting it upwards (3).
Addressing
The Modbus address can be set as follows:
-
hardwarewise:
using DIP switches. The switches increase their bit weight
from right to left, see image with example where address of 21 is set by
activation of switches 4, 6, and 8 with bit weight of 16, 4, and 1 respectively.
Valid settable range is 1 to 254. Address 0 (all switches OFF) means that the
address is set as entered in the Modbus table. Address 255 (all switches ON)
brings the module to INIT mode, where Modbus address is 1 and
communication parameters are set to N, 8, 1, see image below.
All changes apply after the module is switched off and on again.
