Dolphin Hybrid RS1, Руководство по эксплуатации

Страница: 10 / 44

8 Dolphin Hybrid RS 1 - Suction Pool Cleaner
| Operating Instructions
L
M
N
The following are typical problems that might occur and possible solutions.
Table 3: Troubleshooting
Symptom Possible Solutions
The Cleaner does not move or moves slowly
(without indicator light)
• Correct insufficient flow. (Refer to Table 1).
• Remove the service opening cover on the Cleaner bottom
(Drawing L) and clean out any trapped debris (Drawing M) .
• If a track slipped off the wheels, return it. If this occurs
frequently, purchase replacement tracks from your supplier.
• Contact your supplier for repair.
The Cleaner moves on the back wheels only
• Connect additional Hose Sections.
• Correct excessive flow. (Refer to Table 1).
The Cleaner moves on the front wheels only
• Make sure that the Float is in the correct position. (Refer to
“Connect the Cleaner” on page 5).
• Remove the Float from the last Hose Section.
The Cleaner gets stuck on the pool drain
• Make sure to stop operation of the pool drain while the
Cleaner is working.
The hose is twisted
1. Turn the pump OFF .
2. Remove the Cleaner from the pool.
3. Open the swivel and clean it (Drawing N) .
4. Close the swivel properly and make sure the swivel moves freely.
The Cleaner is turning in circles
• The suction is below MIN. (Refer to Table 1).
If does not help, contact your supplier.
Air bubbles at the exit of the water from the
jets, or a noise of air suction
1. Ensure that the hoses are firmly fastened.
2. Ensure that the Leaf Canister lid is firmly closed.