![background image](http://html.mh-extra.com/html/dolmar/ms-27-u/ms-27-u_instruction-manual_2517273016.webp)
16
NYLON CUTTING HEAD
The nylon cutting head is a dual line trimmer head that has bump & feed
mechanism.
The nylon cutting head feeds out the nylon cord after tapping the trimmer head
on the ground.
Operation
– The most effective cutting area is shown by the shaded area.
– To feed the nylon cord, increase the nylon cutting head speed to approx. 6,000
min
-1
and tap the nylon cutting head lightly on the ground.
– If the nylon cutting head does not feed out by tapping, rewind/replace the
nylon cord by following the procedures described under “Replacing the nylon
cord.”
Replacing the nylon cord
– Stop the engine.
– Press the housing latches inward to lift off the cover, then remove the spool.
– Hook the center of new nylon cord into the notch in the center of the spool,
with one end of the cord extending about 80 mm (3-1/8”) more than the other.
Then wind both ends firmly around the spool in the direction of the head
rotation (left-hand direction indicated by LH and right-hand direction by RH on
the side of the spool).
– Wind all but about 150 mm (6”) of the cords around the spool, leaving the ends
temporarily hooked through the notch on the side of the spool.
Most effective cutting area
Cover
Latches
Press
Press
Spool
80 mm (3-1/8”)
For left hand
rotation
Spool
150 mm (6”)
Notches
Содержание MS-27 U
Страница 146: ...146 ...
Страница 147: ...147 ...
Страница 148: ...ALA MS 27U SE8 0614 DOLMAR GmbH Postfach 70 04 20 D 22004 Hamburg Germany http www dolmar com ...