6
DE-1008.5 ASSEMBLY & INSTALLATION
1.
Your
DE-1008.5 Dohrect Enject System
is shipped assembled. Carefully remove the
foam top packaging and lift the DE-1008.5 unit out of the box. Save the original box and
packaging should the applicator need to be shipped in the future.
•
There are additional system components packaged inside the cooler (
Pumping
Tubes
, Wire Harness, SP-2L Control, Flowmeter, Hardware, etc.).
•
If a DE-1008.5X2 has been ordered, the second cooler, baseplate and manifold
(inside the cooler) will be packaged in a second box.
2.
Position the DE-1008.5 basepla
te on the chopper’s fender in the location where you
want it installed and mark the location of the four holes on the bottom of the baseplate.
(If the DE-1008.5-X2 is being installed, be sure to also fit and mark the location of the
additional cooler and baseplate.)
•
NOTE:
Without the cooler on the baseplate containing the pump assembly, the
DE-1008.5 will be tippy prior to being secured to the fender. So, during
installation of the baseplate, it is recommended to place weight on the
baseplate to counterbalance the weight of the pump assembly. Failure to do
so may result in the pump unit tipping over and possibly causing damage or
injury.
3.
Before drilling the holes (3/8”) and securing the baseplate(s) to the fender, you will need
to make sure there is enough clearance to allow the door of the pump enclosure to
open. Keep in mind, the door swings forward
– away from the cooler – from the top and
requires 6.75” of space from the front of the enclosure.
4.
Once you have finalized the location of the baseplate(s), verify the mounting holes are
located over an area safe to drill (no hydraulic hoses, electrical cables, etc.).
5.
After you have confirmed it is safe to drill in the desired
location, drill holes in the fender through the mounting holes in the
baseplate(s) and secure the baseplate(s)
with the included 5/16”
bolts, washers, and nuts, found in the hardware pack, Part #170018.
It is recommended to use a flat washer on the top, under the bolt
head, and a flat washer and Nyloc nut on the underside of the
fender.
170018
