DOGA BMT Series, Инструкция по эксплуатации

Страница: 32 / 68

Manual transducerized BMT series DOC.60425-05/21 30
8.4.1 Command details
Command Description Data (range)
NOP No operation No use
Fastening Tool start fastening process in forward rotation
Selected Preset is fill in Data field Preset selection 1 to 15
Loosening tool start loosening process in reverse rotation Angle in 0.1 turn up to 999
Select preset# Select preset # (not mandatory ) Preset can be
selected in data of Fastening command. Preset selection 1 to 15
Delay time delay for setting time 1 to 999
Jump Move to the setting step 2 to 9
Count value = A Total number “A” to count 1 to 999
Sub if (A)
Subtract 1 from “A” and save the value replacing “A” .
If the value “ A” is not “0”, then move to the next lower
step. If the value “ A” is “0”, then move to 2
nd lower
step
No use
End Finish multi-sequence process (mandatory) No use
8.4.2 Example of Multisequence step program
Step no Command Parameter Description
Step 1 Count Value = A 10 Total counting number is 10.
Step 2 Fastening 1 (Preset #1)
Start fastening with Preset #1 and stop by torque or
angle setting, and move to the next step
Step 3 Loosening 5 Loosen 5 turns and move to the next step
Step 4 Fastening 3 (Preset #3)
Start fastening with Preset #3 and stop by torque or
angle setting, and move to the next step.
Step 5 Sub if (A)
Subtract 1 from “10” and save “9” by replacing “10”.
If the value “ A” is not “0”, then move to the next
lower step. If the value “ A” is “0”, then move to 2
nd
lower step
Step 6 Jump 2 Jump to step no. 2
Step 7 End End
Step no.2 to Step no. 4 works for a cycle. Total 10 cycles are operated automatically by a start signal.
Any failure or NG on each step, Multi-sequence process stops and provide the alarm signal. Once all steps are
finished successfully, there is FASTENING OK signal output. Every successful fastening in steps provide TORQUE UP
signals.