Dog Guard DG-9XT, Руководство пользователя

Страница: 8 / 44

8
The Indoor Room Transmitter works much the same as the outside transmitter. The signal
field radiates outward around the unit at an equal distance in ALL directions (front, back
and sides, see diagram on page 16). This may vary slightly due to the receiver and/or
the transmitter fluctuating in sensitivities as well as the placement and height of the unit.
Normally your only limitation is ensuring the unit is within 10 feet of an outlet (Always
remove your pet’s receiver collar before setting unit up or plugging the unit in!)
The easiest way to set up your
room transmitter is to place
it in the center or near the
problem area, plug it in, make
adjustments and/or relocate
the unit as necessary. Try to
keep the unit at your pet’s
height if possible.
Take your pet’s receiver collar in
your hand and clip the buckle
together. Then holding by the
clip or buckle, approach the
area just as if your pet would if
he/she were wearing it at the
same height and angle.
Move the transmitter itself or turn the range control up or down to get the desired effect,
keeping in mind that the signal can travel through walls, floors and any other objects
within the radius you have set. Test all around (360 degrees) to make certain your pet does
NOT get corrected in any safe zones and IS getting the tone in the desired areas. This can
sometimes be a little tricky but you can usually get the desired effect. (You may need to turn
the transmitter on its side, front or back to change the field slightly).
Once your pet is trained to the desired area, you can move the transmitter to other problem
areas.
Your new room transmitter has 2 lights and 2 recessed adjustments on the front of the unit.
The lights above the adjustments will get brighter as you increase the corresponding level.
Correction level – This control adjusts the actual correction your pet receives. Start out
low. If you need to increase the level, do so in small increments.
range Control – This control sets the distance from the unit that the receiver collar will
activate. Low would be approximately 6 inches and high would be 6 to 8 feet.
Note: Older units work the same as described above except there is no correction
adjustment.
rt-2
InDoor room transmItter