Entry/Exit Mode (Lowers the vehicle approximately 2 in (51 mm)
- This position lowers
the vehicle for easier passenger entry and exit as well as lowering the rear of the
vehicle for easier loading and unloading of cargo. To enter Entry/Exit Mode, press the
“Down” button once from the NHR while the vehicle speed is below 33 mph
(53 km/h). Once the vehicle speed goes below 15 mph (24 km/h) the vehicle height
will begin to lower. If the vehicle speed remains between 15 mph (24 km/h) and
25 mph (40 km/h) for greater than 60 seconds, or the vehicle speed exceeds 25 mph
(40 km/h) the Entry/Exit change will be cancelled. To return to Normal Height Mode,
press the “Up” button once while in Entry/Exit or drive the vehicle over 15 mph
(24 km/h). Entry/Exit mode may not be available due to vehicle payload, an EVIC/DID
message will be displayed when this occurs. Refer to "Electronic Vehicle Information
Center (EVIC)/Driver Information Display (DID)" in "Understanding Your Instrument
Panel" in the Owner’s Manual on the DVD for further information.
Refer to your Owner’s Manual on the DVD for further details.
Air Suspension Modes
The Air Suspension system has multiple modes to protect the system in unique
situations:
Tire Jack Mode
To assist with changing a spare tire, the air suspension system has a feature which
allows the automatic leveling to be disabled. Refer to “Electronic Vehicle Information
Center (EVIC)/Driver Information Display (DID)” in “Understanding Your Instrument
Panel” in the Owner’s Manual on the DVD for further information.
NOTE:
This mode is intended to be enabled with engine running.
Transport Mode
To assist with flat bed towing, the air suspension system has a feature which will put
the vehicle into Entry/Exit height and disable the automatic load leveling system.
Refer to “Electronic Vehicle Information Center (EVIC)/Driver Information Display
(DID)” in “Understanding Your Instrument Panel” in the Owner’s Manual on the DVD
for further information.
NOTE:
This mode is intended to be enabled with engine running.
Wheel Alignment Mode
Before performing a wheel alignment this mode must be enabled. Refer to “Elec-
tronic Vehicle Information Center (EVIC)/Driver Information Display (DID)” in “Un-
derstanding Your Instrument Panel” in the Owner’s Manual on the DVD for further
information.
NOTE:
This mode is intended to be enabled with engine running.
O P E R A T I N G Y O U R V E H I C L E
46