![Docomo P-06C Скачать руководство пользователя страница 21](http://html1.mh-extra.com/html/docomo/p-06c/p-06c_instruction-manual_2515053021.webp)
19
Intr
oduction
Important Information before Use
Before using the FOMA terminal, make sure that you attach the back
cover firmly after tightly closing the connector terminal cover and
inner cover. If there is any small particles (fine fibers, hair or grains
of sand) between the covers and the phone, water could find its way
inside the phone. When attaching the back cover after closing the
connector terminal cover and inner cover, ensure that there is no
particles or dirt on or around these parts (especially the packing).
Ensure that the connector terminal cover, inner cover and back
cover are closed tightly and that none of these covers are askew. If
the covers are not closed tightly, water could find its way inside the
FOMA terminal.
To keep the waterproof performance, you need to replace parts
without fail once two years regardless whether any abnormality with
the FOMA terminal is found or not. You are charged for replacement
of parts. Take your FOMA terminal to a repair counter specified by
DOCOMO.
Opening/Closing the Connector Terminal Cover
■
Opening the connector terminal cover
①
Hook your finger over the groove, pull
out the cover to direction A, and turn it
as direction B.
■
Closing the connector terminal cover
①
Align the connector terminal cover in
parallel with the FOMA terminal, and
while holding its base part firmly, push
it into place.
②
Ensure that no float is found with the
connector terminal cover as a whole.
Removing/Attaching the Back Cover
■
Removing the back cover
①
While pushing the area around the
f
mark down in direction A, slide
the back cover (by 2 mm or more)
in direction B to disengage and
remove the cover.
②
Using the projections on the inner
cover, pull up the inner cover in the
direction shown by the arrow and
open it until it will go no further.
The inner cover should be
firmly closed for maintaining
waterproofness. Opening the cover
forcibly may injure your nails or
fingers.
■
Attaching the back cover
①
Fit the claws at the left, right and bottom sides of the inner cover
into the corresponding indentations, and push the cover into place.
Claw
Packing
Rear surface of inner cover
②
Push the eight
●
marks printed
on the sticker of the inner cover,
and ensure that no float is found
anywhere on the cover.
Hook
Base part
Projection
Содержание P-06C
Страница 1: ...P 06C INSTRUCTION MANUAL 11 7...
Страница 158: ...Kuten Code List...