41
※
The following commands do not result in an error even if specified; however, they do not function as commands.
≥
Command name:
+CGDCONT=[parameter]
[M]
・
Outline
This command sets an access point name (APN) for when dialing for packet communication.
・
Format
+CGDCONT=[<cid>[,"<PDP_type>"[,"<APN>"]]]
・
Explanation of parameters
You set an access point name (APN) for when dialing for packet communication. See the example below for command instructions.
<cid>
※
: 1
to
10
<PDP_type>: PPP or IP
<APN>
※
: Arbitrary
※
The <cid> numbers are used to manage access point name (APN) for packet communication, and they are registered in the FOMA terminal.
Although it is possible to register numbers cid1 to cid10 in the FOMA terminal, “mopera.ne.jp” (PPP) was already registered for <cid>=1, “mopera.net”
(PPP) for <cid>=2, “mopera.net” (IP) for <cid>=3 and “mpr.ex-pkt.net” (PPP) for <cid>=4 prior to purchase. Use numbers 5 to 10 to register other
access point names.
<APN> indicates any character string for each access point name.
・
Operation at omission of parameters
+CGDCONT=
: Sets all the <cid> contents to the default.
+CGDCONT=<cid>
: Sets the specified <cid> to the default.
+CGDCONT=?
: Lists the specifiable values.
+CGDCONT?
: Displays the current setting.
・
Command execution example
AT+CGDCONT=5,"PPP","abc"
OK
※
The command used to register an APN name, abc (cid=5)
※
This command, which is a setting command, is not stored in the nonvolatile memory written by [&W], and is not reset by [&F] and [Z], either.
ATZn
[M]
Resets the setting to the
contents of the nonvolatile
memory. If this command is
entered during communication,
the line is disconnected.
Only n=0 is specifiable. (Can be omitted)
(In online)
ATZ
NO CARRIER
(In offline)
ATZ
OK
AT¥Sn
[M]
Displays the contents of the each
command and S register
currently set.
Only n=0 is specifiable. (Can be omitted)
AT¥S
E1 Q0 V1 X4 &C1
&D2 &S0 &E1 ¥V0
S000=000
S002=043
S003=013
S004=010
S005=008
S006=005
S007=060
S008=003
S010=001
S030=000
S103=000
S104=000
OK
AT¥Vn
[M]
[&F][&W]
Selects the response code
specifications at connection.
n=0: Does not use the extended result code. (default)
n=1: Uses the extended result code.
AT¥V0
OK
・
AT (AT only entered.)
・
ATP (Pulse setting)
・
ATS8 (Setting the pause time by comma dialing)
・
ATT (Tone setting)
・
ATS6 (Setting the pause time taken for dialing)
・
ATS10 (Setting the automatic disconnection delay time)
Supplementary Explanation of AT Commands
AT command
Outline
Parameter/Explanation
Command execution
example
Содержание P-03D
Страница 1: ...P 03D INSTRUCTION MANUAL 11 11...
Страница 139: ...14 10 Click Install Installation starts 11 Click Finish Installation is completed...
Страница 170: ...Kuten Code List...